户外3L登山小口水袋 TPU饮水袋专业骑行运动水袋

商品名称：户外3L登山小口水袋 TPU饮水袋专业骑行运动水袋

商品销量：

收藏数量：1906

店铺名称: 空气睡袋工厂店

旺旺: 丁洋洋29

公司名称:

行业: 运动/户外/女装/流行女装

地址:

店铺名称：空气睡袋工厂店

品名：3L小口水袋

材质：TPU

规格：52.5CM*19CM(长*宽）54.5CM*19 CM（含挂钩长度*宽度）管子长度100CM 注水口小口直径4.5CM

净重：160g

颜色：绿色

水温：- 20℃℃-50℃

50个一箱箱规：60*40*31 净重：8.5KG 毛重：10.5KG

特点：骑车、长跑等高耗氧运动专用，因为在剧烈运动中不能大口饮水，可通过随身携带水袋的水管缓慢补充身体所需要的水分。
100CM标准长水管使水袋即使放在包里可以正常能喝到水。TPU材质环保无毒可放心使用

产品描述：

（1）材料：双面进口TPU。材料具有耐水解性强，抗菌性强，强度高、耐水压高的特性。【符合中国GB国标及美国FDA或 NSF食品级标准，及欧洲EN71不含重金属及毒性测试规范。】

（2）粘合工艺：双面TPU全热合工艺（全过程不使用任何胶水物料，避免可能的有毒物质），强度：耐水压测试大于或等于60公斤

（3）矽胶水密管嘴系统：采用水密型管嘴。这种管嘴加装一个开启和锁闭装置。使用在开启状态【只需轻轻用嘴拉开．饮水方便且安全；锁闭状态时，水不会流出，密封性好；配合矽胶吸嘴设计让饮水时解放双手，方便持续运动、特别适合户外运动和军事用途！

（4）注水口：操作方便，使用安全【不会弄丢盖子】；优质的密封性能设计,盖内有硅胶垫圈,杜绝渗水漏水。

（5）水管：跟袋体及水嘴连接采用三连接套件，这处地方由于经常扯动所以较容易松动，三连套件更加牢固可靠！水管接驳末端有硅胶垫圈杜绝渗水，漏水。

注意事项：

1.由于入水口盖是内螺牙结构，因此为防止漏水，在使用时拧紧扣盖
2.不要装果汁，牛奶等饮料，因为这些饮料可能会对出水口的电压粘合部分造成影响，严重的可能会有渗漏情况。

使用方法：

1.先消毒，用洗洁精清洗后，再用开水烫一遍。

2.注水后拉开密封开关，拔掉吸嘴保护盖，轻咬吸嘴即可。不要装50度以上的水，以免烫伤自己。

店主使用感受及建议：无异味，质感好，想体验水袋带来方便的朋友们别犹豫。

Name: 3L small bag
Brand: AOTU
Model: AT6607
Material: TPU
Specification: 52.5CM*19CM (length * width) CM 54.5CM*19 (with hook length * width) pipe length 100CM water injection port diameter 4.5CM
Net weight: 160g
Color: Green
Water temperature: - 20 c c c -50 C
50 boxes of rules: 60*40*31 net weight: 8.5KG gross weight: 10.5KG
Characteristics: cycling, running, high consumption of aerobic exercise special, because in strenuous exercise not big mouth water, through the carry on Bag Hose slowly supplement the body needs water.
100CM standard long pipes even bag and put it in the bag can be able to drink the water. TPU can rest assured that the use of nontoxic materials
Product description:
(1) double material: imported TPU. The material has strong resistance to hydrolysis, antimicrobial resistance, high strength, high pressure resistance. [China GB conforms to the national standard and the United States FDA or NSF food grade standard, and the European EN71 does not contain heavy metals and toxic test specification. ]
Adhesive (2) process: double sided TPU whole thermal bonding technology (the whole process does not use any glue material, to avoid possible toxic substances) strength: resistance test pressure is greater than or equal to 60 kg
(3) nozzle system silicone tube: adopt watertight watertight type nozzle. The installation of a nozzle opening and closing device. Used in the open state [just gently with the mouth open. Drinking water is convenient and safe; locking state, the water will not flow, good sealing performance; with the silicone suction nozzle design to make drinking water when the hands free, easy to continue to exercise, especially suitable for outdoor sports and military purposes.
(4) nozzle, convenient operation, safe use [don't get lost lid]; excellent sealing performance design, cover silicone washers, to prevent leakage.
(5) pipe: with a bag body, and a nozzle connected with three connection kit, this place because often pulling so easily loose, Triple Suite more secure and reliable! At the end of a silicone rubber gasket to prevent water pipes leaking, Water Leakage.
Note:
1 because of the water cover is internal thread structure, so as to prevent the lid on the Water Leakage, when in use
2. Do not install the juice, milk and other beverages, because these drinks may be voltage for the water outlet of the adhesive portion of the impact, serious may be leaking.
Method of use:
1 before disinfection, with detergent after cleaning, and then scalded with boiling water.
2 after injection and opened the sealed switch, unplug the nozzle cover, the nozzle can nibble. Do not install the 50 degrees above the water, so as not to burn yourself.
The use of feelings and suggestions: no smell, good texture, want to experience the convenience bag friends don't hesitate.